Quantcast
Channel: Automotive Repair Manual Download and Reviews » Search Results » 2013 toyota corolla radio removal
Viewing all articles
Browse latest Browse all 10

Toyota Corolla Exhaust Removal and Installation Instructions

0
0

The first generation (1968-69) Toyota Corolla was the manufacture’s smallest automobile ever released in the United States at that time. The second generation Corolla grew to become the second-best selling automotive on the planet, as acknowledged by Edmunds. As of December 2010, the Corolla is in its tenth generation. The eighth and tenth technology featured similar exhaust system designs, and putting in an exhaust system for the 2001 to 2003 Toyota Corolla S 1.8-liter I-four requires a vehicle carry, a socket wrench set, wrench set and saw with a blade able to cutting metal.

Toyota Corolla Exhaust Removal Instructions

1. Raise the Corolla off the ground utilizing a hydraulic carry or wheel jack and jack stands. Go away sufficient room underneath the automobile to work on the exhaust system elements efficiently.
2. Unbolt the muffler meeting from the swivel bolt flange positioned on the other end of the muffler from the tailpipe using the socket and wrench set. There shall be two flange nuts mating the front pipe and muffler assembly piping together.
3. Lift the muffler assembly off the hanger hooks and pull it out from its mounted position.
4. Place the muffler meeting and all the corresponding hardware and insulators off to the side. Do not lose any of these parts as a result of they may be used in the course of the exhaust alternative installation.
5. Unbolt the chassis brace, located beneath the front pipe. The entrance pipe is located after the resonator assembly. Take away the entrance pipe and place it off to the facet along with all its hardware.
6. Take away the original resonator assembly in case your new exhaust system features a replacement resonator. In this case, reduce the unique resonator piping one to a few inches in entrance of the weld melding the resonator assembly to the exhaust piping leading towards the engine.
7. Prepare to install the new exhaust.

Toyota Corolla Exhaust Installation Instructions

1. Set up the entrance resonator assembly using the hardware and clamps provided by the new exhaust system after slipping it over the recently minimize original piping. Install the new exhaust components from the entrance of the car in the direction of the rear.
2. Bolt the exhaust hangers in place beginning with those that hold the resonator assembly.
3. Set up the front pipe to the resonator meeting utilizing the supplied or stock hardware using the socket and wrench set. Reconnect the chassis brace. If relevant connect the front pipe to the mandatory hangers.
4. Mount the muffler assembly. First join and bolt the swivel bolt flange talked about above utilizing the 2 flange nuts.
5. Cling the muffler assembly on the hangers and tighten the remaining hardware.
6. Regulate the newly installed Corolla exhaust system as needed. Tighten hardware and fasteners from the entrance of the automobile to the rear.
7. Lower vehicle again onto the ground.


Viewing all articles
Browse latest Browse all 10

Latest Images

Trending Articles





Latest Images